Coats Autoflate Automatic Tire Gauge Manuel d'utilisateur télécharger pdf

Technical Characteristics

Electrical Requirement 127 Vac ± 10%

Electrical frequency 50 / 60 Hz

Electrical consumption 10 W

Default pressure 32 psi

Maximum pre-set pressure 90 psi

Minimum supply pressure 100 psi

Maximum supply pressure 175 psi

Average airflow 0,5 m³/min

Accuracy < 1% F. S.

Operating Temperature

+14  +122 °F (-10  +50 °C)

Air relative humidity (without condensation)

0  95%

Weight 6.0 Lbs

Installation

2 For wall mounting:

2.1 Use the unit’s bracket as a guide to pre-drill holes; then install the unit to the wall.

2.2 Place the unit in the bracket.

2.3 Before installing the supply pressure hose, let the air flow for some seconds, so as to

remove all dirt and humidity.

2.4 Install the supply pressure hose and the tire hose.

THE SUPPLY PRESSURE SHOULD NOT EXCEED 175 Psi (12 Bar). IF NECESSARY, USE A

PRESSURE REGULATOR.

2.5 Plug Tire Gauge into a compatible power supply.

Functioning

3.1 Set pressure using buttons and .

3.2 Connect chuck to tire .

Important: DO NOT use to inflate wheels smaller than 10 inches in diameter!

3.3 Wait for the “beep” .

3.4 Push button to inflate.

3.5 Remove chuck from the tire that has been calibrated and repeat the process for

any other tires. If you intend to fill the same pressure value just connect chuck to the

new tire and wait for the beep.

3.6 When set pressure is higher than 40 PSI the unit will stop at 40 PSI and ask for

confirmation. Check tire and press any button to complete tire inflation procedure.

Maintenance

To ensure proper performance and longer life, some procedures are recommended:

4.1 Never allow supply pressure to exceed 175 Psi (12 Bar).

4.2 Chuck must be replaced every time air loss is noticed. ONLY USE AN “OPEN END”

CHUCK”. A closed end chuck will not work properly.

4.3 It is recommended to keep the air line free from dirt to avoid clogging the filter.

4.4 It is recommended to perform a regular cleaning on the front panel using soap

and water.

1 2

Résumé du contenu

Page 1 - Maintenance

Technical Characteristics 1Electrical Requirement 127 Vac ± 10%Electrical frequency 50 / 60 HzElectrical consumption 10 WDefault pressure 32 psiMaximu

Page 2 - Digital Automatic Tire Gauge

Troubleshooting5Er1, Er2, Er4 or Er8 on screen –disconnect tire and reset power, if it continues contact service.Blank Display - check voltage supply.

Commentaires sur ces manuels

Pas de commentaire

Coats Autoflate Automatic Tire Gauge Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Coats Autoflate Automatic Tire Gauge. COATS Autoflate Automatic Tire Gauge User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Coats Autoflate Automatic Tire Gauge